Thermoformers molding plastic sheet on the VacuForge™ 12 x 12 inch thermoform molding vacuum press, including holster and sheath makers, can put a new heat sink board in place with this custom-fit replacement.
The board is sized for the #VP-1212 vacuum press, where it serves as both a vacuum pass-through layer and a work table surface during vacuum forming operations.
The board is reversible, so either face can serve as the work side, and it rests flat on the bottom support table of the press.
Specifications
- Replacement heat sink board for the VacuForge™
- Made to fit Stk.# VP-1212
- Work table surface with a heat sink design
- Thickness of 0.1875 inches
- MDF material
- Offered as a 1-pack
- USA country of origin
